Cadillac

The Mild Mantis Kit for the 2009-2015 Cadillac CTS-V is the only Full angle kit available for this chassis. 

-Angle, 60+ degrees depending on your wheel setup and length of control arms

-Tie-rods, Outer tie-rods  included, these fasten to the stock inner tie-rods 

-Ackermann, ackermann is fixed in a +2 degree position

-Roll Center, factory roll center is maintained

-Bump steer, perfected bump steer for drifting

-Caster, modifications made to the displaced caster amount giving a good self-steer feel for the driver and maximizing the performance for drifting

-Camber, optimized camber ranging from -3 to -6

-Track Width, 25-50mm wider per side creating a stable and high clearance front end

-Suspension Travel, long travel range, full lock to full lock at any point throughout  suspension travel for increased grip 

-Joints, Chromoly heim joints, and spherical bearings with self-lubricating nylon race, easily replaceable 

-Weight Reduction, compact drop knuckle design makes for a lightweight and strong design, 7075 aluminum used where possible which provides steel like strength at 40% weight reduction. 

The Lockout kit for the 2009-2015 Cadillac CTS-V is designed to eliminate the movement of the front lower control arms in the subframe.  

All hardware and plates are included, with an installation video below. 

The all new Universal Handbrake is here. This infront of handle handbrake setup is perfect for any chassis, with easy mounting holes in the base. This design uses our new handle made out of 6061 Billet Aluminum, machined in house. 

Pros to this design:

-Eliminates the side plate design we used to make

-Stronger mounting point for the rod end on the master cylinder

-Lighter, sleeker design

-New anodized black option

-Press fit ball bearings for smooth motion and zero side to side handle movement 

Allow 2-3 week build time

The all new Universal Handbrake is here. This behind handle handbrake setup is perfect for any chassis, with easy mounting holes in the base. This design uses our new handle made out of 6061 Billet Aluminum, machined in house. 

Pros to this design:

-Eliminates the side plate design we used to make

-Stronger mounting point for the rod end on the master cylinder

-Lighter, sleeker design

-New anodized black option

-Press fit ball bearings for smooth motion and zero side to side handle movement 

Allow 2-3 week build time